Thanks to well-developed protection systems on
traditional commercial jets, no airliner crash in the United
States has been caused by lightning in more than 40 years.
It's a remarkable record, since Boeing estimates that every
commercial airplane is hit by lightning on average about
twice a year.
But Boeing engineers designing the 787 face new
challenges, since they are building the first commercial
airframe made entirely from carbon fiber-based plastic.
The composite airframe will not readily conduct lightning
away, as traditional metal ones do.
That means Boeing will have to do more to prevent
lightning from damaging the planes, said Ed Rupke, senior
engineer with respected consulting firm Lightning
Technologies of Pittsfield, Mass.
An airplane often actually triggers a lightning bolt to
the nose, the leading edges, the tail or the wings as it
flies through an electrically charged cloud. The main danger
airplane designers must guard against is sparking inside the
wings, which serve as the jet's main fuel tanks.
Most of the time, after a flash and a bang, lightning
damage is minimal, and airplanes fly on to their
destinations.
Engineers in Everett are debating the best way to achieve
that outcome for a largely plastic airframe. In November,
one top safety-engineering team expressed serious concern.
That team's internal review, obtained by The Seattle
Times, concluded: "It cannot be shown that the current
wing-lightning-protection approach will preclude ignition
sources in the fuel tank."
Walt Gillette, who leads the 787 engineering team as
Boeing's vice president of airplane development, said the
review was part of a healthy internal debate that ultimately
assures the best engineering solution.
Composites are not new in commercial aviation, he said.
And although the safety team's conclusion was "absolutely
true at the time" it was written, he said, by the end of the
testing and analysis now in progress, the 787 will meet
strict Federal Aviation Authority (FAA) requirements.
"It's part of the art of creating
safe airplanes," he said. "No new design can step backward
in safety."
One chance in a billion
Lightning strikes are an unavoidable part of the airline
business. "Getting in and out of airports like Minneapolis
or (others in) the Midwest, (commercial jets) are hit a
lot," said Jack Schroeder, president of Lightning Diversion
Systems, which sells devices for protecting airplanes.
Typically, a bolt moves backward across a wing or
fuselage before the charge exits to the ground milliseconds
later. At the point of entry on a metal skin, the aluminum
can melt, leaving a pitted surface or a small hole.
"You can't hit aluminum with 200,000 amps and expect
nothing to happen," Gillette said. "But it's not a
safety-of-flight issue."
On the composite fuselage of the 787 a strike is unlikely
to penetrate more than the outer layers of carbon fiber.
Such damage needs repair but is not a big deal. More
serious is the possibility that the electric charge passing
through the airplane will create a spark inside the wing,
potentially causing a fuel-tank explosion and destroying the
aircraft.
In 1963, over Elkton, Md., 81 people died when the fuel
tank of a Pan Am 707 exploded in flight, apparently after
being struck by lightning. In 1976 near Madrid, Spain, all
17 people aboard an Iranian Air Force 747 jumbo jet died
when a lightning strike to the wingtip ignited the jet fuel
and blew the wing apart.
The 1963 crash led directly to tighter design
regulations. Then in July 1996, TWA flight 800 exploded over
New York, killing 230 people. Although that explosion was
not due to lightning but was blamed on a wiring short
circuit in the center fuel tank, it brought further
tightening of fuel-tank safety that applied to all new
commercial airplanes developed after 2001, starting with the
787.
"As an industry, we all have reacted with intensity to
the TWA 800 situation," Gillette said, "we want to ensure
that doesn't happen again."
Boeing is taking a multilayered approach to lightning
protection of the 787 fuel tank:
• The initial lightning strike must be dispersed quickly
around the airframe to prevent concentrated damage. Also,
the airplane's electronic flight instruments must be
shielded from disruption by the intense electromagnetic
field. To accomplish this, Boeing will embed a thin metal
mesh or foil in the outer layers of the composite fuselage
and wings.
• A slight gap between a wing-skin fastener and the hole
it goes into could be a source of sparking as current jumps
the gap. Boeing will install each fastener precisely and
seal it on the inside to ensure a snug, spark-free fit.
• Inside the wings, any gap along the
edges where wing skin meets internal structural spars could
cause a spraying out of electrons in a lightning strike — a
phenomenon called "edge glow." Boeing will seal the edges
with non-conducting goop or glass fiber.
• And, in case the efforts to shut out
ignition sources fail, Boeing will install a
nitrogen-generating system (NGS) that reduces flammable
vapor in the wing tanks by filling the space above the fuel
with inert gas.
Last November one safety team became concerned that
Boeing was relying too heavily on tight, precise
installation of the fasteners. It worried that a loose
fastener could not be detected after construction.
"The latent failure of any one fastener leaves the
airplane one event away from a catastrophic incident" caused
by a spark, the team's safety review stated.
The team recommended making the NGS system "dispatch
critical," meaning the airplane is not allowed to take off
if the nitrogen system isn't functioning.
The team was praised for "unwavering determination" in
pursuing its solutions to the lightning-safety issues
"despite the unpopularity of this position with others" —
but its view did not prevail.
"We don't have to make it flight critical," Gillette
said.
Gillette said this kind of debate is common among
engineering teams.
"These are really strongly held opinions by really bright
people," Gillette said. "It's almost like politics — once
you believe in a solution, you really believe in it."
Gillette said that back in November the fasteners were
not working as required — some were pulling right through
the skin.
But Boeing adjusted the fastener design and installation
process. And to test for loosening of the fasteners,
Mitsubishi Heavy Industries, which is making the wings, has
shaken skin panels through the equivalent of one and a half
airplane operating lifetimes.
Extensive tests on fastener installation will be
completed within weeks, Gillette said.
FAA regulations demand a cold statistical outcome: The
787 design has to ensure that the chance of lightning
sparking a fuel-tank explosion in flight is less than one in
a billion.
Gillette said the NGS system is expected to operate at
least 97 percent of the time, but the safety systems
combined will assure the 787 exceeds the one-in-a-billion
probability target.
"It is not a good idea to put all your eggs in one
basket," he said.
Billy Martin, who chairs an industry committee that
provides guidance on lightning-protection standards, said
preventing electrical sparks inside the fuel tank is the
essential lightning-protection element.
The NGS, he said, is "an additional warm-and-fuzzy" added
hastily after the TWA 800 crash.
"I don't believe that's necessary to fly the airplane
safely," said Martin, who is a principal engineer with
business-jet manufacturer Cessna.
Industry experience
Engineers at Boeing and elsewhere note that while the 787
is the first all-composite airframe, the industry has
experience with the material.
Gillette pointed to the Airbus A340, which carries fuel
in its composite horizontal tail — a structure as big as the
wing on a narrow-body jet. More than 300 of those operate
worldwide, with no reports of lightning problems since first
flight in 1991.
"The technology has been safe for the past 25 years or so
in using composites and lightning protection," said Rupke of
Lightning Technologies. "I think the confidence is there to
use that technology."
Boeing "will have to do a lot of testing, a lot of
analysis and provide the FAA a lot of data" to show the 787
meets the same protection standard as an aluminum airplane,
said Dave Walen, the agency's chief scientific and technical
adviser on lightning.
Gillette said his team is perhaps only months away from
agreeing with the FAA on an overall 787 certification plan,
which will include proving that the risk of a
lightning-induced fuel-tank explosion is less than one in a
billion.
"When it's all done, the end of a five-year process ...
the FAA will evaluate all that we have done," Gillette said,
"and they will find that we have met the rule."
Dominic Gates: 206-464-2963 or
dgates@seattletimes.com
from
this link